____________________________________________________________________________________
____________________________________________________________________________________
62 VoIP subscriber gateways
– Stop dialing at # – when checked, use ‘#’ button on the phone unit to end the dialing, otherwise ‘#’
will be recognized as a part of the number.
Supplementary services:
– Flash mode – flash function operation mode (short clearback):
Transmit flash – transmit flash into the channel using one of the methods described in
'Profiles' tab, 'Flash transmission' parameter);
Attended calltransfer – flash dialing will be processed locally by the device (call transfer
will be performed when the connection with the third party is established). For the
'Attended calltransfer' detailed operation algorithm see in section 5 Added service usage;
Unattended calltransfer – flash dialing will be processed locally by the device (call transfer
will be performed when the subscriber finishes dialing a third party number). For
'Unattended calltransfer' detailed operation algorithm, see Section 5 Added service
usage;
Local calltransfer – call transfer inside the device without sending a message REFER. For
‘Local calltransfer’ detailed operation algorithm, see Section 5 Added service usage;
– Callwaiting – when checked, 'Call waiting' service will be enabled otherwise – disabled (this service
is available in 'flash—call transfer' function operation mode);
– Direct number – when the phone goes offhook, dial the defined number immediately;
– Hotline/warmline – when checked, 'Hotline/warm line' service is enabled. This service allows you
to establish an outgoing connection automatically without dialing the number after the phone
handset is picked up with the defined delay (in seconds). When checked, fill in the following fields:
Hot number – phone number that will be used for connection establishment upon 'Delay
timeout' expiration after the phone handset is picked up (in SIP profile being used, a
prefix for this direction should be defined in the numbering schedule.);
Hot timeout, sec – time interval that will be used for connection establishment with the
opposite subscriber, in seconds;
– Call forward unconditional (CFU) – when active, all incoming calls will be forwarded to the specified
number. When flag is set fill in the following fields:
Call forward unconditional number (CFU number) – number that all incoming calls will be
forwarded to if ‘CFU’ service is enabled (in SIP profile being used, a prefix for this direction
should be defined in the numbering schedule.);
– Call forward on busy (CFB) – when active, all incoming calls will be forwarded to the specified
number, if the subscriber is busy. When flag is set fill in the following fields:
To Next Page
Loading...
