ELTEX TAU-8.IP - Firewall Rules Submenu

____________________________________________________________________________________
____________________________________________________________________________________
VoIP subscriber gateways 73
– High Security – incoming traffic is forbidden (from WAN to WLAN), outputting traffic (from WLAN
in WAN) is forbidden.
You may set the rules permitting reception/transmission traffic to specific address in the ‘Firewall rules’
submenu.
To save changes into the device operative memory, click ‘Save changes’ button. To record settings into
the non-volatile memory, click ‘Apply’ button.
3.1.5.2 ‘Firewall Rules’ submenu
Use the submenu to set transit traffic rules.
Description of ‘Firewall rules’ table.
Firewall rule configuration:
To add new rule, click ‘Add’ button and fill in the following fields:
– Name – user-friendly character name of rule;
– Traffic type –type selection of traffic that satisfies this rule:
– INPUT – incoming traffic. When this traffic type is selected, the following fields will be
available for editing:
Starting source IP address – specify start IP address of source. You may assign subnet
mask after ‘/’ symbol (for example 192.168.16.0/24) to extract all the address range.
When ‘Address number of source’ parameter is not taken into;
Number of source IP addresses – use the field to specify address range of source, if
address mask of source is not specified;
– OUTPUT – outgoing traffic. When checked, the following fields will be available to edit:
Starting destination IP address – specify destination IP address. After ‘/’ you may
assign subnet mask (for example, 192.168.18.0/24) to extract all the range of
addresses. When mask is assigned, ‘Destination address number’ is not taken into
account;
Number of destination IP addresses – use this field to assign address range of receiver
if receiver mask is not specified;
Changes in the submenu will be applied immediately after pressing ‘Apply’ button. Reboot is
not required.