EasyManua.ls Logo

ELTEX TAU-8.IP - FXS Submenu; FXS Ports

ELTEX TAU-8.IP
102 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
____________________________________________________________________________________
____________________________________________________________________________________
VoIP subscriber gateways 59
QoS Configuration
Minimal port number for UDP connections (UDP port min) the lower limit of the RTP port range
used for voice traffic transmission;
Maximal port number for UDP connection (UDP port max) the upper limit of the RTP port range
used for voice traffic transmission;
RTP DSCP DSCP field value of IP packet header for voice traffic (it is set for hexadecimal number
system);
Signalling DSCP DSCP field value of IP packet header for signal traffic (it is set for hexadecimal
number system);
Reserved IP this IP address and the next IP will be reserved for internal the device requirements.
255.255.255.0 is subnet mask. It is not recommended to assign IP addresses from the subnet on
external network interface;
To save changes into operative memory of the device, click Save changes button. To record settings into
the non-volatile memory, click 'Apply' button.
3.1.4.3 FXS submenu
Use the menu to configure subscriber line unit of the device.
For physical line parameters, you may create separated FXS profiles. It is handy tool for device
configuration when customer units have the same parameters. In this case, it is sufficient to configure one FXS
profile with required line parameters after that specify this profile to each FXS port.
3.1.4.3.1 FXS ports
For fast transition to Status/Telephony’ submenu, click ‘FXS status’ (section 4.2.8) where monitoring
statistic of customer unit status, call groups and series selection groups are available.
FXS profile when No profile value is set line physical parameters are assigned for all FXS port
individually otherwise configuration of one from assigned FXS port is used for customer unit
physical parameters (section 3.1.4.3.2 FXS profiles).
To edit customer unit settings, click button in Action colon of common table.
Full list of customer port parameters is shown below.
Changes in this submenu will be applied immediately after pressing the Apply button. Reboot
is not required.

Table of Contents

Other manuals for ELTEX TAU-8.IP

Related product manuals