ELTEX TAU-8.IP - Wi-Fi Submenu

____________________________________________________________________________________
____________________________________________________________________________________
36 VoIP subscriber gateways
During the activation of manual mode of key exchange, the following settings will be available:
– Authentication algorithm – select an authentication algorithm from the list: HMAC-MD5,
NMAC-SHA1, HMAC-SHA2-256, HMAC-SHA2-384, HMAC-SHA2-512;
– Authentication key – key authentication is assigned in dependence on selected algorithm;
– Encryption algorithm – select an encryption algorithm from the list: DES-CBC, 3DES-CBC,
Blowfish-CBC, Cast128-CBC;
– Encryption key – encryption key is assigned in dependence on selected algorithm;
– Security Parameter Index – identifying tag added to IPSec header. It helps to the hub to differ
two data streams involving different encryption algorithms;
– Remote subnet start IP address in cooperation with ‘Remote subnet address count’
determines address list to establish IPSec tunnel. Addresses should locate in subnet
determined by ‘Remote subnet’ and ’Remote subnet mask’ parameters.
3.1.2.3 ‘Wi-Fi’ submenu
The submenu is available for TAU-8.IP-W devices.
Use the submenu to configure wireless network.
Wi-Fi Configuration:
— Enable Wi-Fi – when checked, option of wireless access to the device is enabled;
Wireless network name (SSID) is set in the ‘Network’ menu (tab ‘Network settings’)
separately for each service. SSID field becomes active if you select the Tagged/Untagged of
‘Access mode via Wi-Fi’. These settings will be applied to all the configured access points.
– Channel number for Wi-Fi – channel number for wireless network operation;
– Operating mode – wireless interface operation mode:
– 802.11b – if all the Wi-Fi clients support standard 802.11b;
– 802.11bg – if network has Wi-Fi clients with 802.11b and 802.11g support;