ELTEX TAU-8.IP - Page 83

____________________________________________________________________________________
____________________________________________________________________________________
VoIP subscriber gateways 83
– testing – test of subscriber line;
– Remote number – when connection is established, this field displays the number of opposite
subscriber;
– Registration – when registration on SIP server is successful, this field displays registration time. If
registration is failed, the field will display ‘No registered’ record;
– Registrar address – SIP server address of registered subscriber;
– Line test – start parameter test corresponding to the subscriber line port.
Test of ports
‘Test’ button opposite each of ports allows you to test parameters corresponding subscriber
line port. Click this button to begin test (test continues about 1 minutes). When test is finished,
you may click ‘Result’ button to view test results which contains the following information:
– Date of test;
– Foreign DC voltage А (TIP);
– Foreign DC voltage B (RING);
– Line supply voltage;
– Resistance А (TIP) – B (RING);
– Resistance А (TIP) – Ground;
– Resistance B (RING) – Ground;
– Capacity А (TIP) – B (RING);
– Capacity А (TIP) – Ground;
– Capacity B (RING) – Ground.
Hunt groups status – this table displays registration status of configured hunt groups. Click ‘Hunt groups
settings’ to switch to the ‘PBX/Hunt groups’ section of hunt group settings (see 3.1.4.4).
– Group name – group identifier name;
– Phone – phone number assigned to the group;
– Ports in group – list of the device port included in the hunt group;
– Registration – registration status of group phone number on SIP server (if a phone number is
registered you will see registration time otherwise you will see the record ‘Not registered’).
Serial groups status – shows registration status of configured serial groups. Click ‘Serial groups settings’
button to forward to the ‘PBX/Serial groups’ configuration section (see section 3.1.4.7 for detailed description).
– Group name – identification group name ;
– Phone – phone number assigned to the group;
– Ports in group – list of the device port included in the hunt group;
– Registration – registration status of group phone number on SIP server (if a phone number is
registered you will see registration time otherwise you will see the record ‘Not registered’).