Ordering numbers
50
6.7 Packaging
Fig. 14: Packing
Before packing, the analyzer must be wrapped in plastic foil to protect it from
moisture and dust, and then be placed in a wooden case. The wrapped analyzer
should be surrounded by a layer of plastic foam (or at least chips) of at least 10cm,
in order to avoid any damage during transport.
Especially the foam where the analyzer is put on is very important. It should neither
be too hard nor too soft. When the foam is too soft, the analyzer will practically
touch the wood. Fix the foam on the bottom of the wooden case by gluing.
The small loader (with 36 trays) can be packed in the wooden case together with
the analyzer. The bigger loaders (for 104 and 130 crucibles) however, are to be
packed in separate carton boxes and protected by foam or another shock
absorbing material. The transportation of these carton boxes has to be made on
pallet.
The glass tubes must be empty.
To Next Page
Loading...
Need help?
General
