To Next Page
R
russellsmithAug 3, 2025
What to do if I'm unable to rectify a fault on the ELTRA ELEMENTRAC CS-i analyzer?
- Ddavid87Aug 3, 2025
If you are unable to rectify the fault, please contact Service.
What to do if I'm unable to rectify a fault on the ELTRA ELEMENTRAC CS-i analyzer?
If you are unable to rectify the fault, please contact Service.
General| Brand | ELTRA |
|---|---|
| Model | ELEMENTRAC CS-i |
| Category | Measuring Instruments |
| Language | English |
Explanation of signs and symbols used in the Manual.
Manual disclaimer regarding modifications and liability.
Copyright notice for the manual content.
Information on safety officer responsibilities and target user definition.
Explanation of the different safety warning levels (DANGER, WARNING, CAUTION).
General safety rules and precautions for operating the machine.
Identification and meaning of safety symbols found on the machine.
Procedures for emergency stops and description of residual risks.
Description of components visible on the front of the ELEMENTRAC CS-i.
Description of components visible on the rear of the ELEMENTRAC CS-i.
Safety precautions for installation, including electrical and load handling.
Steps for setting up the analyzer, including PC, power, and gas connections.
Conditions that must be met before commissioning the machine.
Step-by-step guide to commission the ELEMENTRAC CS-i.
Warnings regarding chemicals, combustion gases, and hot parts during operation.
Detailed steps for conducting sample analyses using the software.
Detailed technical data including dimensions, electrical, and environmental parameters.
Explanation of labels and information found on the analyzer's type plate.
List of standards the analyzer meets for inorganic material analysis.
Basic procedure for identifying and resolving analyzer faults.
Instructions for safely cleaning the outer surfaces of the machine.
Table detailing components, intervals, and service instructions for regular maintenance.
Safety and procedures for filling and inserting reagent tubes.
Steps for replacing the dust filter cartridge on the analyzer.
Procedures for replacing combustion tubes and O-rings in the furnace area.
Steps to clean the hose connecting the furnace to the metal filter.
Lists spare parts for the front and internal components of the analyzer.
Spare parts related to the furnace assembly.
Warnings and procedures for working with high voltage components.
List of parts for the optional gas purification furnace.
Information on the disposal of electrical and electronic equipment according to regulations.
