Risk of burns
Hot machine parts
− Parts of the machine can get very hot and cause burns during
maintenance work if the waiting time to ensure cooling is not complied
with.
• Before maintenance work, wait until the temperature of the furnace
is < 40 °C.
• Check the furnace temperature in the ELEMENTS software.
10.1.1 Overview of maintenance work for the analyzer
The following service instructions refer to the usual steel analyses using the analyzer with 10 to
30 samples per day and 99.5 % pure oxygen. Depending on the application, the maintenance
cycle may need to be intensified to maintain the precision of analysis results.
The following table lists the maintenance work to be carried out. The maintenance work must
be conducted regularly at the specified maintenance intervals or upon reaching the number of
possible analyses:
To Next Page
Loading...
Need help?
General
