Need help?Do you have a question about the ELTRA CS-580A and is the answer not in the manual?
General| Detection method | Infrared (IR) |
|---|---|
| Carbon range | 0.0001% - 10% |
| Sulfur range | 0.0001% - 5% |
| Resolution | 0.0001% |
| Application | Carbon and sulfur determination |
| Sample form | Various (e.g. powder, granules, solids) |
| Materials | Metals, alloys, and other materials |
Details how the analyzer is packaged for safe transport and handling.
Provides instructions and warnings for transporting the analyzer safely.
Specifies environmental and operational requirements for installing the analyzer.
Explains the information provided on the device's type plate for identification.
Covers safety precautions and setup checks before operating the analyzer.
Illustrates and labels the components on the front panel of the analyzer.
Details installing furnace covers for manual and autoloader setups.
Details safety warnings and procedures for connecting the analyzer to the mains power.
Explains the microcontroller board and its various interface connectors.
Provides instructions and safety warnings for connecting the oxygen supply.
Describes the different modes of the mains power switch and their functions.
Details how to adjust the flow rates for different gases used by the analyzer.
Explains how to adjust the furnace temperature via PC software.
Provides instructions and considerations for preheating the furnace.
Outlines general safety warnings and procedures before starting an analysis.
Step-by-step guide for performing analyses using the autoloader.
Step-by-step guide for performing analyses with manual sample loading.
Introduces the optional module for Total Inorganic Carbon determination.
Details the steps for installing the TIC module alongside the analyzer.
Step-by-step guide for operating the TIC module for sample analysis.
Describes analysis parameters for different sample materials.
Provides general guidance on chemical replacement and analyzer cleanliness.
Details safety precautions and methods for cleaning the analyzer.
Covers safety warnings and procedures for replacing reagent tubes.
Specifies safety warnings and guidelines for filling chemicals into reagent tubes.
Explains the fundamental principle of sample combustion and gas analysis.
Illustrates and explains the flow path of gases through the analyzer.
Describes the function and components of the infrared cells used for detection.
Explains the role of the MCU and PC software in signal processing and control.
Lists part numbers and descriptions for components visible on the analyzer's front.
Identifies components visible on the rear exterior of the analyzer.
Identifies components visible on the bottom exterior of the analyzer.
Identifies components visible on the left interior side of the analyzer.
Identifies components visible on the interior side of the furnace.
To Next Page
