Fire hazard / Risk of burns
Hot parts (crucibles, reagents,...) can fall down
− Ignition of tables, floors, or any other surface the hot part falls on
− Ignition of clothes and any other material
• Set up the analyser in a flame retardant environment. Pay special
attention to the table, the floor and any other surface being in the near
of the analyzer
• Always wear suitable clothing
• Keep the work environment clear of all materials that could catch fire
• Install the needed covers as given in the following chapters
5.3.1 Manual Setup
If the Helios analyser was delivered without an autoloader system, it is configured to be used in manual
mode. In this case, please install the side cover plate (article number 35400-2003).
To Next Page
Loading...
Need help?
General
