Need help?Do you have a question about the ELTRA CS800 and is the answer not in the manual?
General| Sample form | Solid |
|---|---|
| Protection Class | IP20 |
| Elements to be measured | Carbon, Sulfur |
| Sample weight | Up to 1g |
| Combustion technique | Induction furnace |
| Detection method | Infrared (IR) |
| Accuracy | 0.5 % (depending on sample weight and homogeneity) |
| Resolution | 0.0001% |
| Power Supply | AC 230V, 50/60 Hz |
| Application | Carbon and sulfur determination |
Provides an overview of loader models and space requirements for setup.
Describes the three standard loader models available and their differences.
Specifies the necessary space around the analyzer for loader placement.
Details how to connect and disconnect pneumatic and other plastic tubes.
Explains the physical mounting and connection of the autoloader to the analyzer.
Describes how to check and adjust the tension of the chain motor belt.
Details the procedure for adjusting the chain tension for proper operation.
Provides step-by-step instructions for adjusting the loader's fingers.
Guides the user through the process of installing the loader's arm assembly.
Explains how to connect the electrical and pneumatic interfaces of the loader.
Details how to adjust the vertical position of the loader's arm.
Explains how to use the single-step mode for making mechanical adjustments.
Discusses the vertical laser's function and safety precautions.
Covers the horizontal laser's role and necessary safety measures.
Explains how to use the single-step mode for mechanical adjustments.
Details how to adjust the fingers' position relative to the pedestal.
Describes how to adjust the speed of the finger's vertical movement.
Explains how to align the crucible position with the fingers.
Details the procedure for adjusting the platform height for crucible placement.
How to repeat the single step cycle for verification.
Explains how to operate the loader in a continuous, non-stop cycle mode.
Lists and explains the error codes signaled by the loader's buzzer.
Final steps after all adjustments are made for proper installation.
Provides basic maintenance recommendations for the loader.
Describes how to switch the loader from adjustment to analysis mode.
Instructions for setting up the system for collecting and disposing of used crucibles.
To Next Page
