Need help?Do you have a question about the ELTRA CS-800 and is the answer not in the manual?
General| Brand | ELTRA |
|---|---|
| Model | CS-800 |
| Category | Measuring Instruments |
| Language | English |
Describes analyzers with flow sensor and HF-3/HF-4 boards.
Addresses base line voltages outside the +9.5V or -9.5V range.
Discusses causes of unstable gas flow rates and potential obstructions.
Details troubleshooting steps for when the sample fails to combust.
Identifies reasons for excessive analysis duration and potential causes.
Addresses circuit breaker trips occurring during initial combustion phases.
Details troubleshooting for insufficient oxygen supply pressure.
Covers scenarios where analysis fails to initiate or show a peak.
Troubleshoots abnormal IR signal behavior post-analysis.
Details how to adjust the gas flow controller and configure jumpers.
Provides instructions for calibrating and adjusting IR base lines.
Guides on maintaining and replacing IR paths.
Covers the service and maintenance of infrared electronic components.
Lists and explains general test points for diagnostics.
Details specifications and service for the IR power supply.
Instructions for handling and replacing IR sources.
Procedures for performing leak tests on the system.
Steps for cleaning solenoid valves.
Guidance on replacing or cleaning the flow sensor.
Instructions for installing the halogen trap.
Configuration and functionality of the gas saving mode.
Lists part numbers for various components.
Details different types of infrared cells and their specifications.
Explains components and layout of the front panel.
Diagram and list of pneumatic components.
Diagram of the oscillating circuit with component labels.
Exploded view and part numbers for furnace components.
Instructions and parts for cleaning the furnace.
Electrical wiring diagrams for the analyzer.
Schematic of the gas flow system.
Timing diagrams for valve operations during analysis.
Details parts included in the common spare parts kit.
Lists spare parts specific to the CS-800 model.
Recommends checking IR cell base lines as part of maintenance.
Procedure for cleaning IR paths and readjusting base lines.
Advises checking or replacing the metal dust filter.
Procedures for performing leak tests on the system.
Suggests testing furnace power by burning samples.
To Next Page
