Machine falling down
Incorrect installation or insufficient working space
– Due to its weight, the machine can cause injuries if it falls down.
• Only operate the machine in a sufficiently large, robust, non-slip and
stable working area.
• Ensure that all machine bases are placed securely on the surface.
The space required to set up the ELEMENTRAC CS-i with balance and PC is approx. 160 cm ×
75 cm (width x depth), without balance and PC approx. 80 cm × 75 cm.
The machine bench must be able to safely withstand the weight of the machine (see “Technical
data”). The power plugs must be easily accessible at all times. The surface of the machine
bench must be non-slip and fire-resistant.
Set the machine up as follows:
1. Set the machine up on the prepared workstation.
2. Ensure that the power plugs on the analyzer are freely accessible at all times.
3. Make sure to set up both machines in a way that does not block the fans.
4. Set up the PC, monitor, keyboard and balance in the desired place.
5. Ensure that the machine is secure and stable.
6. Ensure that the surface of the workstation is non-slip and fireproof.
7. Make sure that no crucibles are able to roll down from the surface.
8. Ensure that there are no flammable objects or materials (work papers, files) near the
analyzer.
The machine set up is complete.
To Next Page
Loading...
Need help?
General
