EM TEST CWS 500N2 - Function Check Amplifier Switch ( 1 Ghz Model Only)

EM Test CWS500 N2
User manual V 3.00 20 / 38
5.4.
Function Check amplifier switch ( 1GHz model only)
This function is for checking the correct operation of the built in amplifier switch. During this test the output
connector at the frontside should be left open.
The function check has the following procedure:
Page 3 (Service )
Function check amplifier switch
Fig 5.4
- Press TEST ON
- Disconnect the HF OUT
- Connect the SG OUT directly
to the CPL IN ( on the backside )
continue break
F1
F2
F3
F4
F5
F6
F7
Page 3 (Service )
Function check amplifier switch
result
Pass / Fail
end
F1
F2
F3
F4
F5
F6
F7