Emaldo Power Core User Manual
resulting in death, serious personal injury or serious property loss. Therefore, before any
maintenance work, the equipment must be powered down and operated in strict accordance
with the safety precautions listed in the Manual and other related documents.
• Maintain the equipment under the condition that you are familiar with and understand the
contents of the Manual and have suitable tools and testing devices.
• Before maintenance, first power down the equipment, and then follow the instructions of
the delayed discharging label and wait for the corresponding time to ensure that the
equipment is powered down before operating the equipment.
• During maintenance, try to avoid irrelevant personnel from entering the maintenance site.
Temporary warning signs or fences must be erected for isolation.
• If the equipment fails, please contact your dealer in time.
• The equipment can only be powered on again after the fault has been handled; otherwise,
the fault may be enlarged or the equipment may be damaged.
• Do not repair without authorization; otherwise, there will be danger of electric shock, and
the resulting failure is not within the warranty scope.
• Operation and maintenance personnel and professional technicians should be fully trained
in safe use and equipment maintenance, and should operate with adequate preventive
measures and protective equipment.
• When it is necessary to move or rewire, the power input must be cut off. After waiting for 5
minutes, the internal energy of the machine is completely discharged, and the multimeter
is used to confirm that there is no dangerous voltage in the internal parts to be repaired
before the maintenance can be started.
• Maintenance of batteries should be carried out or supervised by personnel who are
familiar with batteries and the necessary preventive measures.
• When replacing the battery, replace the same type of battery or battery pack.
• After the maintenance operation, check immediately to ensure that no tools or other parts
are left in the equipment.
• If the equipment is not used for a long time, store the battery and charge it according to
the Manual.
To Next Page
Loading...
