Emaldo Power Core User Manual
disconnection from the system, please install HVDC isolators, circuit breakers or accessible
fuses according to local regulations. To avoid electric shock, please turn off the main
switch of the energy storage system at least 5 minutes in advance before any installation
or maintenance.
• Please completely disconnect all power supplies before carrying out any maintenance. Do
not open the outgoing line compartment on the upper right side of the system. Do not pull
the AC/DC cable when the energy storage system is running.
Warning: Risk of burns
• During operation, the inside and outside of the cabinet will get hot. Please do not open the
cabinet or touch any internal parts. Before any maintenance operation, please allow
enough time to cool the internal components of the energy storage system.
Warning: Risk of fire
• Please do not store inflammable and explosive articles and equipment in the same room.
• Ensure that the dimensions of AC cable, DC cable and ground cable meet local
specifications. For dimensions requirements, please refer to the product brochure. Ensure
that all conductors are in good condition, and it is forbidden to use damaged or
substandard cables.
Caution: Equipment damage
• Please check thoroughly before starting the equipment to ensure that there are no tools or
equipment left.
• Ensure that the spacing requirements are strictly observed. Keep all vents open and the air
around the equipment circulating smoothly.
• Static electricity can damage sensitive electrical devices in the equipment. When touching
the equipment, please make sure to eliminate static electricity and wear appropriate
protective equipment.
• Do not open the cabinet cover of the energy storage system. In addition to operating the
terminal according to the instructions in the Manual, any other operation or replacement of
modules without EMALDO's authorization may lead to equipment damage or personal
injury, and warranty failure.
To Next Page
Loading...
