POWERJET MANUAL
8f749dd9-8865-44fd-baed-1b68166d2198file.doc
POWERJET OWNERS INSTALL & OPERATE MANUAL
Notice
The contents of this manual are subject to change without notice. Portions of this document may have been updated.
The Manufacturer reserves the right to make equipment changes and improvements which may not be reflected in this document.
We recommend that this document be read in its entirety before any attempt is made to operate the equipment.
Copyright © 2000-2016 Equipment Mfg. Corp. Printed in U.S.A. All Rights Reserved
WARNING
HOT ! ALLOW TO COOL BEFORE
HANDLING MACHINE OR CONTENTS.
THIS MACHINE IS INTENDED
TO PROCESS WATER ONLY.
USER IS SOLELY LIABLE FOR
SUITABILITY OF OTHER LIQUIDS.
USE ONLY NON-FLAMMABLE,
NON-TOXIC, WATER SOLUTION
COMPATIBLE WITH OPERATION
& MATERIALS OF CONSTRUCTION
CAUTION !
Please completely read and review this manual before installation
and start-up of the system.
The EMC ® POWERJET ® is designed for use with
water-based, Non-Flammable fluids only !
The user is responsible for determining the applicability of their fluid
with the materials of construction and function of this unit.
A Qualified Gas Technician should perform the installation and the
initial startup and calibration of the GAS Burner assembly, if the unit
is so equipped.
Failure to follow cautions and operating procedures contained in
this manual may void the warranty and could lead to dangerous and
unsafe conditions.
WARNING !
Always disconnect Electrical and Gas utilities prior to servicing
the EMC ® POWERJET ® parts washer.
Electrical Approval Conditions:
1. Not Suitable for Hazardous / Classified Areas
2. This device shall only be installed, maintained and used by authorized and qualified personnel.
3. This equipment shall be permanently grounded in accordance with the National Electrical Code.
4. The final installation of this system shall comply with all the local and national codes.
5. This device is only evaluated for fire and shock hazard, its performance and accuracy have not been investigated.
To Next Page
Loading...