PURPOSE OF USE
AND SAFETY
WARNINGS
EQUIPMENT INTENDED FOR DRINKING WATER TREATMENT
The pump must only be used for dosing liquid products.
It must not be used in explosive environments (EX).
It must not be used to dose flammable chemicals.
It must not be used with radioactive chemical material.
Only use the pump after installation.
Use the pump in accordance with the data and technical specifications
on the label.
Do not modify or use it in any other way than specified in the operating
manual.
Keep the pump protected from sun and rain. Avoid splashing water.
During an emergency of any kind in the room where the pump is installed,
immediately cut off the power to the system and disconnect the pump
from the power socket.
If particularly aggressive chemical materials are used, regulations on the use and
storage of these substances must be strictly followed.
Always observe local safety regulations.
The dosing pump manufacturer cannot be held liable for damage to
persons or property caused by improper installation, misuse or incorrect
use of the dosing pump!
Install the dosing pump so that it is easily accessible whenever maintenance
is required.
Do not obstruct the location of the dosing pump!
The device must be connected to an external control system. In the event
of a water shortage, dosing must be stopped.
Service and maintenance of the dosing pump and all its accessories must
always be carried out by qualified personnel.
Before any installation and maintenance work:
•
Carefully read the chemical characteristics of the product to be dosed
and refer to the product's safety data sheet;
•
Wear suitable SAFETY DEVICES;
•
Drain the dosing pump connection pipes;
•
Carefully wash any hoses that have been used with particularly
aggressive chemical materials.
To Next Page
Loading...
