[9]
Table 3-1: LED blinking pattern (continued)
Event
Blinking pattern
Sequence
(1)
Automatic calibration
with Machine Studio –
failure detected
Unlimited fast flashing (5 Hz) – until power off/
on the EZ 1000
Firmware update Slow flashing (1 Hz) while waiting for button
press
Steady light while erasing and writing the
firmware
Sensor error LED off
Sensor is too close to
the measuring object
Converter error
No power supply
Factory default Continuously triple flashing
Factory calibrated Slow flashing (1 Hz) for approximately 3 seconds
after power on the EZ 1000
(1)
= on /
= off
To Next Page
Loading...