Figure 4-3: Overview – open AMS Asset Monitor
A. Ethernet switch with two RJ-45 connectors (left connector: LAN2.1, right connector
LAN2.2) to daisy chain AMS Asset Monitors
2
, speed 100 Mbit/s
B. RJ-45 Ethernet connector LAN1 for configuration and connection to subsequent systems,
speed 1 Gbit/s
C. Status light
D. CHARM baseplate with 12 slots for up to 12 CHARM terminal blocks, 12 CHARMS, and a
CHARM labeling component
E. Mounting holes
F. Door hinge
G. Screws holes for securing the door
H. Power module slot
I. Address plug slot
J. External grounding terminal
K. Power supply terminals
L. Non-functional. For internal use only.
M. microSD Card slot (for future use)
N. Reset button with status LED
O. Internal grounding terminals
+24 V DC Power Module
The +24 V DC Power Module is used to supply the AMS Asset Monitor including all installed
CHARMs.
2
Because of the possible network traffic, Emerson recommends to daisy chain no more than eight AMS Asset Monitors.
Installation Guide Installing AMS Asset Monitor hardware
MHM-97923-PBF March 2024
MHM-97923-PBF, Rev. 2.10 25
To Next Page
Loading...
