Procedure
1.
Connect the provided power supply cord into an outlet and to the
analyzer.
Note
Refer to precautions for the battery pack and power adapter.
The Battery LED is amber to indicate the battery pack is charging. The
analyzer is activated.
2.
Press and hold the power key
to turn the analyzer on.
The Home screen appears when you turn on the analyzer. The time and
date are set to a default value.
3.
To set the time and date, press Home > ALT > F3 Set Time.
Battery pack
A rechargeable Lithium-Ion battery pack powers the analyzer. A typical
charge should last for more than 8 hours of continuous use. The analyzer
displays a low-battery warning when the remaining charge reaches a set
level; the default is 15 percent. If the battery pack fully discharges, you do not
lose any data or settings.
The battery pack is shipped in storage mode to protect the battery charge.
Refer to Turn on the analyzer for the first time to activate the battery pack.
You do not need to discharge or calibrate the battery pack. The hardware
optimizes battery pack performance. Contact technical support if you
experience any problems or for instructions on how to store or replace the
battery pack.
WARNING!
Use only Emerson battery packs with the CSI 2140. The analyzer will not
function if a non-Emerson battery pack is used. Lithium-Ion batteries have
very specific charging requirements. Emerson power supplies and chargers
are designed to work with the Emerson Lithium-Ion battery pack. Using
battery packs other than approved Emerson battery packs could not only
void the warranty, but could also be hazardous.
March 2016 Quick Start Guide
MHM-97430 Rev 4 7
To Next Page
Loading...
Need help?
General
