3.5 T-200 transducer assembly removal and
installation
WARNING
CONTENTS MAY BE HAZARDOUS
The meter must be fully depressurized and drained before attempting to remove the
T-200 transducer assembly. If gas or fluid begins to leak, stop immediately and reinstall
the transducer assembly. Failure to comply may cause serious injury or equipment
damage.
Figure 3-12: T-200 transducer assembly
The T-200 transducer assembly shown in the figure offers improved transducer alignment
and superior acoustic isolation between the transducer and the meter housing. The net
result is improved performance and stability. The assembly can be used on 4" to 12" Daniel
3410 Series meters. The gas temperature ranges are as show in Table 3-1.
Maintenance and Troubleshooting manual Meter repairs
P/N 3-9000-769 June 2019
Maintenance and Troubleshooting manual 71
To Next Page
Loading...
Need help?
General
