Emerson Daniel Senior Orifice Fitting Series - Material List

Owner and operator manual Section 5: Supplemental information
3-9008-001 Rev M January 2015
Material List 111
5.5.2 Material List
The field technician will need to verify that all materials necessary for the retro-fit are included in
the parts kit prior to beginning this procedure. Below is a breakdown of those parts and
quantities (refer to Figure 5-6 for pictorial reference). Should any parts be missing, contact your
authorized Daniel representative for replacement parts.
Table 5-7 Material list
Item no. Description Material
Numbered
required
3-SS Soft Seat Slide Valve Strip 5/16 X 1-3/8 410 SS Flat Bar 1
9A Sealing Bar Gasket (9A, 9A-HP or 9CF) Nitrile/Cotton duct “compoflex” 1
15-SS Soft Seat Slide Valve Spring Inconel X750 2
16-SS Spring Loaded Slide Valve Carrier Guides
(2" - 14" only-not shown in Figure 5-6)
VC Guide Base — 316SS
VC Leaf Spring - Elgiloy
2
17-SS Soft Seat Slide Valve Carrier 316SS 1
17A Slide Valve Carrier Stop Pin (tapered
dowel)
CS 2
17B Plate Carrier Positioner 316SS 1
18-SS Soft Seat Slide Valve Seat 316SS 1
18A Slide Valve Seat / Body-Top Gasket Aramide Fiber/NBR binder non-Asbestos
Flat Sheet
1
23C 1/4" NPT Pipe Plug (to replace fitting's
Grease Gun Assembly)
CS 1
23D Soft Seat Slide Valve Warning Plate 304SS 1
45 Soft Seat O-Ring HNBR — other materials optional 1
46 Slide Valve Assembly Flat Washer 18-8SS 2
47 Slide Valve Assembly Machine Screw 18-8SS 2
48 Soft Seat Slide Valve Operating Instruction
Plate (to replace existing Instruction Plate)
304SS 1
Daniel Tool #J-01955, Recommended Tool
to Remove Existing Instruction Plate (not
included in this parts kit, but can be
purchased separately, Daniel part number
1-201-99-021)
1