Emerson Dixell iChill IC207D - KEY FUNCTION

1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 11/192
Probes visualization
“OFF” visualization
3.11 HOW TO READ COMPRESSOR STATUS
if a compressor is disable for maintenance the display shows:
compressor 1 disabled: label c1ds
compressor 2 disabled: label c2ds
compressor 3 disabled: label c3ds
compressor 4 disabled: label c4ds
3.12 KEY FUNCTION
KEY
ACTION
FUNCTION
Push and release
Show chiller set point SetC and heat pump SetH
Push once again
In chiller or heat pump if the Energy saving or the
Dynamic setpoint are enabled it shows the real
setpoint Setr.
Push for 3 seconds
Set point modification
During the programming: push
once
To enter parameter modification or confirm a value
Push when an alarm is showed in
menù ALrM
To reset the alarm
Push once with probe label
showed on the bottom display
(press up or down starting from
default visualization)
To read probes values of circuit 1 or circuit 2
Push once
To read probes value
Pushing once during the
programming
To change the group of parameters, to change the
parameter, to change the value of the parameter