1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 10/192
3.8 DISPLAY VISUALIZATION IN CONDENSIG UNIT
If the Ichill is used to control a condensing unit (CF03=1):
and a digital input has to be configured as “cooling request”; in case of cooling request the
display shows “OnC”
and a digital input has to be configured as “heating request”; in case of heating request the
display shows “OnH”
If the Ichill is used to control a condensing unit (CF03=1):
and a digital input has to be configured as “regulation request”; in case of cooling request by key
the display shows “OnC”; in STD-BY the display swows “On”, when the digital input is not active
the display shows “OFF”
and a digital input has to be configured as “regulation request”; in case of heating request by key
the display shows “OnH”; in STD-BY the display swows “On”, when the digital input is not active
the display shows “OFF”
3.9 DISPLAY VISUALIZATION IN REMOTE OFF
Digital input configured as remote ON/OFF: the active input sets the unit in OFF (even when the unit is a
condensing unit).
The upper display shows “OF.F ”, the led of the decimal point is blinking.
3.10 DISPLAY VISUALIZATION IN STD-BY
It is possible to customise the visualization of the display when the unit is in STD-BY:
Parameter dP10:
0= the display shows "STD-BY"
1= the display shows what defined by parameters dP1 and dP2
2= the display shows “OFF”
“Stby” visualization
To Next Page
Loading...
