1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 25/192
SSP2 Solar panel probe 2 temperature
SSdi Solar panel differential
SPMP Solar panel water pump status
SLrL Solar panel valve status
9.18 READ-OUT OF THE TIME COUNTING TO THE NEXT DEFROST
dF FUNCTION
Label involved in dF function:
dF1 delay time to next defrost of the circuit 1
dF2 delay time to next defrost of the circuit 2
Enter the function menu :
1. Use the UP or DOWN keys to select dF
2. Push SET key: the dF1 label is showed on the top display, the bottom display shows the time delay to
next defrost in minutes / seconds. The icon is on.
3. Use the UP or DOWN keys to select dF1 or dF2.
To exit the Hour function push MENU key or wait the timeout
9.19 READ-OUT OF THE PROBES CONFIGURED TO CONTROL AN AUXILIARY
OUTPUT RELAY
uS FUNCTION.
Label involved in uS function:
uSt1 auxiliary 1 probe value
uSt2 auxiliary 2 probe value
Enter the function menu
1. Use the UP or DOWN keys to select uS.
2. Push SET key: the label uSt1 (temperature probe) or uSP1 (Pressure probe) is showed on bottom
display, the top display shows the the temperature or pressure value.
3. Use the UP or DOWN keys to select uSt1 auxiliary 1 probe or uSt2 auxiliary 2 probe.
4. To exit the Hour function push MENU key or wait the timeout.
9.20 HOW TO DISPLAY THE TEMPAERATURE OF THE INTERNAL TEMPERAURE
SENSOR OF THE REMOTE TERMINAL 1 OR 2
Inside the funcion menu it is possible to see the ambient temperature detected by the NTC sensor
FUNCTION trEM to show the temperature of the remote panels
Identification label trEM.
trE1 value of the NTC probe of the remote #1
trE2 value of the NTC probe of the remote #2
Select with UP or DOWN the trEM function
Push SET the trE1 or trE2 label is shown on the bottom display, the top display shows the probe value.
Use the UP or DOWN arrow to change beteween trE1 or trE2 read-out.
To exit to the normal display read-out push MENU or wait the time – out time.
ATTENTION:
THE trEm function and the labels trE1 or trE2 appear only if the CF56 = =2 or 3 (remote panel 1
configuration) or if the parameter CF56 = 2 or 3 (remote panel 2 configuration).
9.21 ON BOARD CLOCK (OPTIONAL)
If giving power supply the bottom display shows “rtC” alternated with a temperature or pressure value, It is
necessary to set the internal clock.
After a power failure, clock back-up battery lasts maximum 3 or 4 days. After this period it is necessary to set
the clock again.
The internal clock is an option and it is not possible to update the instrument; it is necessary to order
the instrument already complete of this features.
To Next Page
Loading...
