1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 27/192
10.2 MAIN VISUALIZATION
In the main visualization it is possible to read:
status of the unit: cooling, heating, remote OFF or STD-BY
date and time, available if the Ichill is provided by internal clock
4 probes value; it is possible to manage 4 lines to visualize the probe temperature / pressure
(parameters dP06..dP09)
0. Not enabled
1. Temperature probe PTC for compressor 1 discharge
2. Temperature probe PTC for compressor 2 discharge
3. Temperature probe PTC for compressor 3 discharge
4. Temperature probe PTC for compressor 4 discharge
5. Temperature probe PTC for compressor 5 discharge
6. Temperature probe PTC for compressor 6 discharge
7. Temperature probe PTC for solar panel
8. Temperature probe NTC for evaporator inlet
9. Temperature probe NTC for evaporator 1 outlet
10. Temperature probe NTC for evaporator 2 outlet
11. Temperature probe NTC for common evaporator outlet
12. Temperature probe NTC for common hot water condenser / recovery inlet
13. Temperature probe NTC for hot water of the condenser / recovery circuit 1 inlet
14. Temperature probe NTC for hot water of the condenser / recovery circuit 2 inlet
15. Temperature probe NTC for hot water of the condenser / recovery circuit 1 outlet
16. Temperature probe NTC for hot water of the condenser / recovery circuit 2 outlet
17. Temperature probe NTC for hot water of the condenser / recovery common outlet
18. Temperature probe NTC for free cooling water inlet circuit
19. Temperature probe NTC for dynamic setpoint external air / boiler / change over
To Next Page
Loading...
