1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 28/192
20. Temperature probe NTC for combined defrost circuit 1
21. Temperature probe NTC for combined defrost circuit 2
22. Temperature probe NTC for auxiliary output 1
23. Temperature probe NTC for auxiliary output 2
24. Temperature probe NTC domestic hot water 1
25. Temperature probe NTC domestic hot water 2
26. Temperature probe NTC solar panel
27. Temperature probe NTC recovery function
28. Condenser probe circuit 1 ( temperature NTC / pressure 4÷20 mA / ratio-metric 0÷ 5Volt )
29. Condenser probe circuit 2 ( temperature NTC / pressure 4÷20 mA / ratio-metric 0÷ 5Volt )
30. Evaporator pressure probe circuit 1 (pressure 4÷20 mA / ratio-metric 0÷ 5Volt )
31. Evaporator pressure probe circuit 1 (pressure 4÷20 mA / ratio-metric 0÷ 5Volt )
32. Aux 1 output probe control (4÷20 mA / ratio-metric 0÷ 5Volt)
33. Aux 2 output probe control (4÷20 mA / ratio-metric 0÷ 5Volt)
34. Dynamic setpoint probe (4÷20 mA)
35. Compressor 1 or circuit 1 pressure probe
36. Compressor 2 or circuit 2 pressure probe
37. Internal temperature of the Visograph 2.0 remote terminal (sensor mounted internally)
38. Remote temperature of the Visograph 2.0 remote terminal (external sensor)
39. Internal humidity of the Visograph 2.0
load / function status as showed below:
Compressor/s
(blinking during the start
up delay)
Economy or ON/OFF by
timetable
Meaning of the keys:
Allows to read the value
of the probes configured
in the Ichill
Allows to read/modify the
set point
Allows to switch on the
Ichill in heating or cooling
mode (see parameter
CF78)
Allows to read the alarms
Allows to switch on the
Ichill in heating or cooling
mode (see parameter
CF78)
Allows to enter the
SERVICE menù
Allows to put the Ichill in
STD-BY
Allows to read the main
information of the circuits
(compressor status,
water pump status,
pressure probe value,…)
Note:
in case of alarm, press any key to silence the buzzer
To Next Page
Loading...
