1
Installation and Maintenance Manual
E2K-401-0817 Rev. 1
August 2017
Storage Instructions
Section 1: Storage Instructions
1.1 Short Term Storage
(Stored at job site less than one year from shipment)
1. Actuator should be stored in the recommended mounting position. The motor
should be horizontal and Electrical Enclosure either horizontal or vertical.
Figure 1
2. Actuator should be stored indoors free from job site dirt, mud, moisture and
temperature changes.
3. If indoor storage is not possible, the actuator must be stored off the ground, above
possible water or snow level. Remove MCP and store with other electrical and
electronic equipment in protected warehouse. If MCP is not removed,
Space Heater MUST be energized to protect Electrical and Electronic Controls.
4. EIM supplies plugs in each conduit entry. Do not remove until electrical hook-up.
5. Cover units loosely with a plastic sheet. This serves as partial protection from rain.
1.2 Long Term Storage
(Stored more than one year from shipment)
1. Store indoors or MCP must be removed and stored in protected area. Follow
procedures of short term storage.
WARNING:
Failure to store actuator properly will void warranty of electrical & electronic components.
Section 1: Storage Instructions
To Next Page
Loading...
