S600+ Field Upgrade Guide
Note: Only version 3.0 (and greater) of Config600 supports the
enhanced functionality of the new CPU module.
1. Start Config600.
2. Select Tools > Transfer from the PCSetup main menu. The Config
Transfer screen displays (see Figure 13).
Figure 13. Config Transfer Screen
3. On the Transfer tab, verify that the TCP/IP address in the
Hostname field corresponds to the TCP/IP address you assigned
the S600+.
4. Select the Send tab and select a configuration to download to the
S600+.
5. Click Send. A Select Target Folder dialog displays.
Note: The S600+ can store up to 20 configurations, and
automatically sets the last configuration downloaded as the
default configuration. Use the Config Selector option on the
Cold Start menu to select a different default configuration.
6. Highlight the target folder (“slot”) for this configuration. Press ▼
to display a sequence of all available slots.
Note: The S600+ lists any configurations already loaded.
7. Click OK. The utility displays a dialog monitoring the transfer.
Figure 14. Transfer Monitor
14 Revised Feb-11
To Next Page
Loading...
Need help?
General
