S600+ Field Upgrade Guide
Note: A security cap may cover this hex screw.
2. Carefully slide the front panel up 4 mm to allow it to clear the
retaining groove at the top of the case, and then allow the panel to
come forward to clear the case completely.
Figure 2. Lifted Front Panel
3. Disconnect the ribbon cable from the back of the front panel at the
blue connector.
Disconnect
Here
Figure 3. Ribbon Cable
Proceed to the next step.
4. Install the Printed Circuit Board (PCB)
1. Place the front panel faceplate button-side down on a flat surface.
2. Remove the eight screws that secure the printed circuit board
(PCB) to the faceplate (see Figure 4).
Revised Feb-11 3
To Next Page
Loading...
