Emerson MICRO MOTION 2700 - Page 339

Manual Setup menu: Measurements (continued)Figure D-10:
On-Line Menu >
2 Configure >
1 Manual Setup >
2 Measurements
1
2
3
8
7
9
10
Pressure
1 Pressure Unit
2 Pressure Compensation
3 Compensation Pressure
4 Flow Cal Pressure
5 Flow Press Factor
6 Dens Press Factor
Temperature
1 Temperature Unit
2 External Temperature
3 Correction Temperature
External Polling
1 Poll Control
2 Ext Dev Tag 1
3 Polled Variable 1
4 Ext Dev Tag 2
5 Polled Variable 2
External Pressure/Temperature
1 Pressure
2 Temperature
3 External Polling
Petroleum Measurement *
1 2540 CTL Table type
2 TEC
3 Ref Temperature
4 Petroleum Msmt Setup
GSV
1 Volume Flow Type
2 Gas Ref Density
3 GSV Cutoff
4 GSV Flow Unit
5 Gas Density Unit
Conc Measure (CM) **
1 CM Configuration
2 Matrix Configuration
3 Enter Matrix
4 Trim CM Process
Variables
5 Reset Matrix Data
* Displayed only if petroleum
measurement is enabled on your
transmitter. Menu numbers are
adjusted as required.
** Displayed only if concentration
measurement is enabled on your
transmitter.
Using the Field Communicator with the transmitter
Configuration and Use Manual 331