Emerson MICRO MOTION 2700 - Page 5

5.6.6 Configure Sensor Liner Material .................................................................................... 97
5.6.7 Configure Sensor Flange Type .......................................................................................98
Chapter 6 Integrate the meter with the control system ..................................................................99
6.1 Configure the transmitter channels .............................................................................................99
6.2 Configure the mA output ..........................................................................................................100
6.2.1 Configure mA Output Process Variable .......................................................................100
6.2.2 Configure Lower Range Value (LRV) and Upper Range Value (URV) .............................102
6.2.3 Configure AO Cutoff ...................................................................................................104
6.2.4 Configure Added Damping .........................................................................................105
6.2.5 Configure mA Output Fault Action and mA Output Fault Level ....................................107
6.3 Configure the frequency output ................................................................................................108
6.3.1 Configure Frequency Output Process Variable ............................................................108
6.3.2 Configure Frequency Output Polarity ..........................................................................110
6.3.3 Configure Frequency Output Scaling Method .............................................................111
6.3.4 Configure Frequency Output Maximum Pulse Width ..................................................112
6.3.5 Configure Frequency Output Fault Action and Frequency Output Fault Level ..............113
6.4 Configure the discrete output ...................................................................................................114
6.4.1 Configure Discrete Output Source ..............................................................................115
6.4.2 Configure Discrete Output Polarity .............................................................................118
6.4.3 Configure Discrete Output Fault Action ......................................................................119
6.5 Configure events .......................................................................................................................120
6.5.1 Configure a basic event ...............................................................................................121
6.5.2 Configure an enhanced event .....................................................................................121
6.6 Configure digital communications ............................................................................................124
6.6.1 Configure HART/Bell 202 communications .................................................................124
6.6.2 Configure HART/RS-485 communications ..................................................................129
6.6.3 Configure Modbus/RS-485 communications ..............................................................130
6.6.4 Configure Digital Communications Fault Action .........................................................131
Chapter 7 Completing the configuration ......................................................................................135
7.1 Test or tune the system using sensor simulation ........................................................................135
7.1.1 Sensor simulation .......................................................................................................136
7.2 Back up transmitter configuration .............................................................................................137
7.3 Enable write-protection on the transmitter configuration .........................................................138
Chapter 8 Set up the Weights & Measures application .................................................................139
8.1 Weights & Measures application ................................................................................................139
8.2 Set up the Weights & Measures application using ProLink II .......................................................140
8.3 Set up the Weights & Measures application using ProLink III ......................................................143
Part III Operations, maintenance, and troubleshooting
Chapter 9 Transmitter operation .................................................................................................149
9.1 Record the process variables .....................................................................................................149
9.2 View process variables ...............................................................................................................150
9.2.1 View process variables using the display .....................................................................150
9.2.2 View process variables using ProLink III .......................................................................151
9.3 View transmitter status using the status LED .............................................................................152
9.4 View and acknowledge status alarms ........................................................................................152
9.4.1 View and acknowledge alarms using the display .........................................................152
9.4.2 View and acknowledge alarms using ProLink II ............................................................155
Contents
Configuration and Use Manual iii