Emerson Micro Motion ELITE Installation Manual

Figure 3-14: Feedthrough and extender components
G
H
E
D
C
A
B
F
A. Transmitter or core processor
B. Extender
C. O-ring
D. Feedthrough
E. Clamping ring
F. Clamping screw
G. Plastic plug
H. Plastic cap
2. Loosen the clamping screw and remove the clamping ring. Leave the O-ring in place
on the feedthrough.
3. Remove and recycle the plastic plug from the extender.
4. Fit the extender onto the feedthrough by carefully aligning the notches on the
bottom of the extender with the notches on the feedthrough.
5. Close the clamping ring and tighten the clamping screw to 13 in lbf (1.47 N m) to
18 in lbf (2.03 N m).
Mounting Installation Manual
October 2021 20002158
28 Micro Motion ELITE

Emerson Micro Motion ELITE Specifications

General

Brand	Emerson
Model	Micro Motion ELITE
Category	Industrial Equipment
Language	English