Emerson Process Management GmbH & Co. OHG2-10
X-STREAM XE
Short Form Manual
HASXEE-SFM-HS
05/2017
Important note for X-STREAM XEFD!
Due to the special conditions which must be observed when installing units in EX zones / hazard-
ous areas, the installation of the ameproof X-STREAM XEFD version is described in a separate
instruction manual HASXEDE-IM-EX.
Even if you do not install your X-STREAM XEFD in an EX zone / hazardous area, please install
the unit according to the instructions in the separate manual.
Installation instructions: X-STREAM XEGK & XEGP page 2-11
X-STREAM XEXF eld housings page 2-16
Notes for wiring signal inputs and outputs page 2-24
Important note for analyzers measuring traces of oxygen!
The electrochemical sensor used for this measurement is a consumable. Remaining lifetime
counts down when the sensor is in contact with oxygen.
For above reasons, concerned analyzers are shipped with the sensor as extra item in a sealed bag!
The sensor must be installed before analyzer startup, according the instructions shipped with
the sensor!
2.6 Installation - Electrical Connections
To Next Page
Loading...
