EMKO EAOM-6 - Page 14

Table 3.1 Unit wiring
Output to start solenoid
2.5
Description
Cable Size (mm)
Notes
Table 3.1 shows the connections and recommended cable sizes. Table 3.2 describes the
functions of the connections.
1
Positive battery supply input
Output to fuel solenoid
3
Output to horn
4
Configurable output-2
Configurable output-1
Positive battery supply input
7
8
9
Alternator neutral
14
L1 alternator input
L2 alternator input
L3 alternator input
Input from charge generator
18
Input from low oil pressure switch
Input from high temperature switch
Input from remote start/stop switch
21
Emergency stop input
22
Input from spare switch 1
Input from spare switch 2
Input from spare switch 3
Input from magnetic pick-up
Input from magnetic pick-up
2.5
2.5
1.0
1.0
1.0
2.5
2.5
2.5
1.0
1.0
1.0
1.0
1.0
0.5
0.5
0.5
0.5
0.5
0.5
0.5
0.5
0.5
Max. 12A@24 VZ
Supplies external solenoids
Max. 12A@24 VZ
Max. 5A@24 VZ
Max. 5A
Max. 5A
For relay outputs
3-phase only
3-phase only
Terminal must be left
unconnected if not used
Switch to 0 VZ(NC)
Switch to 0 VZ(NO)
Switch to 0 VZ(NO)
Switch to 0 VZ(NC)
Switch to 0 VZ(NO)
Switch to 0 VZ(NO)
Switch to 0 VZ(NO)
Negative battery supply input
Negative battery supply input
Pin
2
5
6
23
24
25
26
27
15
16
17
19
20
14