EMKO EAOM-6 - 5.3 Changing and Saving Technician Parameter Value

V
L31/L3N
V
L23/L2N
V
L12/L1N
Hz
RPM
PROGPROG
RESETRESET TESTTEST
Operation Screen
When button is
pressed, all leds and digits
are energised, because
prog button is also used as
test button. Continue to
press the prog buton for 5
seconds, Operator Menu
Entering screen is shown
and prog led lights on.
V
L31/L3N
V
L23/L2N
V
L12/L1N
Hz
RPM
PROGPROG
RESETRESET TESTTEST
V
L31/L3N
V
L23/L2N
V
L12/L1N
Hz
RPM
PROGPROG
RESETRESET TESTTEST
When button is pressed
for 10 seconds, technician
menu entering screen is
shown.
V
L31/L3N
V
L23/L2N
V
L12/L1N
Hz
RPM
PROGPROG
RESETRESET TESTTEST
Technician Password
Entering Screen
Change the password with
and buttons
After entering the
password, press the
button for confirming the
password and accessing to
the first parameters of
technician parameters.
Operator Menu
Entering Screen
V
L31/L3N
V
L23/L2N
V
L12/L1N
Hz
RPM
PROGPROG
RESETRESET TESTTEST
Technician Menu
Entering Screen
When button is
pressed, technician
password entering screen
is shown.
Technician Password
Entering Screen
5.3 Changing and Saving Technician Parameter Value
30
NOTE : If no operation is performed for 20 seconds, the device exits from the
programming mode and turns to the main operation screen.