EMKO EAOM-6 User Manual

5.2 CHANGING and SAVING OPERATOR PARAMETER VALUE
5.3 CHANGING and SAVING TECHNICIAN PARAMETER VALUE
9. FAULT FINDING.................................................................................................................................
10.PROGRAMMABLE PARAMETERS..................................................................................................
11.SPECIFICATIONS..............................................................................................................................
6. LAMP TEST.........................................................................................................................................
7. OPERATION.......................................................................................................................................
7.1 FRONT PANEL DESCRIPTION
7.2 DISPLAY MODE INDICATORS
7.3 STARTING THE ENGINE
7.4 STOPPING THE ENGINE
8.COMMISSIONING...............................................................................................................................
9.1 FAULT INDICATIONS
9.1.1 FAILED TO START LED
9.1.2 HIGH TEMPERATURE LED
9.1.3 LOW OIL PRESSURE LED
9.1.4 CHARGE GENERATOR FAILURE LED
9.1.5 OVER / UNDER SPEED LED
9.1.6 GENERATOR VOLTAGE FAILURE LED
9.1.7 SPARE-1, 2, 3
9.1.8 EMERGENCY STOP MESSAGE LED
9.1.9 LOW BATTERY VOLTAGE MESSAGE (bAT1)
9.1.10 WEAK BATTERY ALARM MESSAGE (bAT2)
9.1.11 ROUTINE MAINTENANCE DUE (SErV)
Page 32
Page 36
Page 40
Page 33
Page 35
Page 38
4

EMKO EAOM-6 Specifications

General

Brand	EMKO
Model	EAOM-6
Category	Controller
Language	English