Hydrating the Sensors
Open the Saline Hydration Sensor Pack with the white felt inserts inside. The inserts will eventually
be mounted in the headset arms but must be properly wetted with saline solution first. Begin
wetting each of the felt inserts with the supplied saline solution. The felts should be wet to the
touch, but not soaking wet!
Note: This is standard multipurpose contact lens saline solution and is available from any local drug
store in case you run out of solution. However, the bottle supplied with the kit should be sufficient
initially. See the User Manual on the EPOC CD setup disk for recommendations.
Add a few drops of saline to saturate the large white hydrator pad attached to the top cover of the
hydrator, then close the cover and gently shake the hydrator pack. This will maintain the moisture
of the felt pads when they are not in use. Open the pack and check that each of the pads had been
wetted. If not fully wetted, then add a drop or two of saline to any pads not sufficiently wet using the
dropper bottle. Be careful not to over-wet the pads. If you have connection problems, add more
saline to each felt pad.
To Next Page
Loading...
