EMS AIRFLOW Prophylaxis Master - Device Use; 3.1. Interfaces

ENGLISH
FB-618/AU – rev.E – ed.2019/08
17/48
3. DEVICE USE
3.1. Interfaces
ON/OFF-mode
Standby
ON: the device goes into operating mode.
OFF: the device reverts back to standby.
(After 1 hour of inactivity, the unit switches to off-mode standby)
Powder chamber
pressurization /
depressurization
Powder chamber is pressurized or depressurized.
A white light illuminating the powder chamber will turn on when pressurized.
During chamber depressurization, the AIRFLOW
®
cord will automatically purge and the
white light will turn off at the end of the process.
Entering Standby mode: The powder chamber depressurizes automatically.
Powder chamber depressurization may take up to 10 seconds to complete.
During this time, it is recommended that you leave the AIRFLOW
®
Handpiece in its
holder with the nozzle facing down to avoid spraying the purged air and residual
powder upwards.
Power setting
Place your finger in the groove below the numbers to adjust AIRFLOW
®
air pressure
and PIEZON
®
power:
• 0 (water only, blue indicator)
• 10 (Maximum)
Memorization of the preselected settings.
PIEZON
®
water
Sets the PIEZON
®
water flow rate.
AIRFLOW
®
water
Sets the AIRFLOW
®
water flow rate.
Pedal (normal)
Press the edge of the pedal for normal operation.
The pedal is deactivated when both handpiece cords are placed in their holders.
Pedal BOOST
(Only on the wireless pedal)
Pressing hard on the center of the wireless pedal activates power boost.
For easy boost activation: leave the foot on the pedal and put the heel up.
1
2
3
4
5
6
7
1
2
4
5
3
7
6
BOOST
Press hard
NORMAL
Press gently