EMS AIRFLOW Prophylaxis Master - 3.2. Treatment sequence

ENGLISH
FB-618/AU – rev.E – ed.2019/08
21/48
3.2. Treatment sequence
Consult the Treatment Recommendations (document series FB-648) before starting any
treatment to the patient.
AIRFLOW
®
1
Position the powder chamber.
2
Pressurize the chamber.
3
Set the AIRFLOW
®
power.
4
Set the water flow.
5
Take the AIRFLOW
®
Handpiece.
6
Press the pedal to start treatment.
7
[Step hard on the center of the BT pedal for
BOOST.]
8
Release the pedal to stop treatment.
9
Put the handpiece back into its holder.
PIEZON
®
1
Set the PIEZON
®
power.
2
Set the water flow.
3
Connect the PIEZON
®
bottle (if required).
4
Take the PIEZON
®
Handpiece.
5
Press the pedal to start treatment.
6
[Step hard on the center of the BT pedal for
BOOST.]
7
Release the pedal to stop treatment.
8
Put the handpiece back into its holder.
Treatment does not stop immediately. Beware there is a small delay between the release of the
pedal and the effective stop of the treatment (approximately 0.2 second).
Risk of patient injury. If you are not trained on a specific treatment, do not execute it.
Always get trained before executing new treatments.
1
4
2
3
5
6
7
8
2
1
3
4
5
6
7