EMS FirePoint 5000 Step-By-Step Guide

EMS 5000 FIREPOINT
©2015 EMS Security Group Ltd. All rights reserved. TSD258 Iss 3 25/06/15 AJM
11
17 Press NO key three times and the screen will
display:
18 Turn the Control key switch to the off
position and the screen will now display:
Note: The isolate LED on the 5000 FirePoint Master Panel and the 5000
FirePoint Slave Panel 04 will illuminate with intermittent beep to show
there is an isolation on the system.
7. How To Re-instate an Isolated Device Across A Network
To re-instate an isolated device across the network on the 5000 FirePoint,
Insert the key into the panel controls keyswitch, located at the right of the
panel.
Step Action Screen Display
No
1 Turn the key to the on position and the
screen will display:
2 Press 0 key and the screen will now display:
3 Press  key three times and the screen will
display:
4 Press Yes key and the screen will now
display:
5 Press  key one time and the screen will
display:
Panel in Access
Date Time
Status Normal
Date Time
|***Options ****|
>Passwords <
|Time and Date |
Yes =Select Time
|Logging |
>Fire System Opts<
|Remote Access |
Yes = select Time
|** Fire system **|
>Dev. Isolate/Test<
| Net. Isolate/Test |
Yes= Select Time
|Dev. Isolate/Test |
>Net. Isolate/Test <
|Zone Isolate/Test |
Yes= Select Time
Panel in Access
Date Time

EMS FirePoint 5000 Specifications

General

Brand	EMS
Model	FirePoint 5000
Category	Control Panel
Language	English