Endress+Hauser Cerabar PMC11 - Mechanical Construction; Design, Dimensions; Electrical Connection

Cerabar PMC11, PMC21, PMP11, PMP21
Endress+Hauser 29
Mechanical construction
• The following dimensions have been rounded up to whole measurements.
• Exact dimensions are available in the Product Configurator on the Endress+Hauser website:
www.endress.com → Product finder → On the product page, click the "Configure" button to the
right of the product photo.
Design, dimensions Device height
The device height is calculated from
• the height of the electrical connection
• the height of the housing and
• the height of the individual process connection.
The individual heights of the components are listed in the following sections. To calculate the device
height simply add up the individual heights of the components. Where applicable also take into
consideration the installation distance (space that is used to install the device). You can use the
following table for this purpose:
Section Page Height Example
Electrical connection →  29 (A)
A
D
B
C
A0027252
A
D
B
C
A0022829
Housing height →  30 (B)
Process connection height →  32
→  35
(C)
Installation distance - (D)
Electrical connection
A
20.5 (0.81)
M12x1
A0024426
B
20.5 (0.81)
M12x1
A0024427
C
34 (1.34)
51 (2.01)
A0024428
D
27 (1.06)
45 (1.77)
r ³ 102 (4.02)
A0024429
Engineering unit mm (in)
Position Designation Material Weight kg (lbs) Device Option
1)
A M12 plug IP65
(Additional dimensions →  47)
Housing cap made of plastic 0.012 (0.03) PMC11
PMP11
L
A M12 plug IP65/67
(Additional dimensions →  47)
Housing cap made of plastic 0.012 (0.03) PMC21
PMP21
M
Plug connector with cable
can be ordered as an accessory →  47
B M12 plug IP66/67 Housing cap made of metal 0.030 (0.07) PMC21
PMP21
In the case of Ex ec type of protection,
the housing cap is made of metal.