Deltabar S FOUNDATION Fieldbus Commissioning
Endress+Hauser 41
6.6.2 Information on differential pressure measurement
!
Note!
• There is a Quick Setup menu for each of the measuring modes Pressure, Level and Flow which
guides you through the most important basic functions. With the setting in the MEASURING
MODE parameter, you specify which Quick Setup menu should be displayed. See also
Page 24, Section 6.2 "Selecting the language and measuring mode". No Quick Setup menus
are available for the FF configuration programs.
• For a detailed description of the parameters, see Operating Instructions BA00303P "Cerabar
S/Deltabar S/Deltapilot S, Description of Device Functions"
– FF, Table, Pressure Transducer Block
– FieldCare, Table, POSITION ADJUSTMENT
– FieldCare, Table, BASIC SETUP
– FieldCare, Table, EXTENDED SETUP
6.6.3 Quick Setup menu for the Pressure measuring mode
P01-xMD7xxxx-19-xx-xx-xx-080
Fig. 16: Quick Setup menu for the "Pressure" measuring mode
1)2)1) 2)
1)
1) On-site display only
2) FieldCare only
PROFILE VIEW
POS. ZERO ADJUST
DAMPING VALUE
MEASURED VALUE
QUICK SETUP
GROUPSELECTION
MEASURING MODEMEASURING MODELANGUAGE
FlowPressure Level
OPERATING MENU
To Next Page
Loading...
