Gammapilot FMG50 HART Basic safety instructions
Endress+Hauser 5
Bluetooth®
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG,
Inc. and any use of such marks by Endress+Hauser is under license. Other trademarks and
trade names are those of their respective owners.
3 Basic safety instructions
3.1 Requirements for personnel
The personnel for installation, commissioning, diagnostics and maintenance must fulfill the
following requirements:
• Trained, qualified specialists must have a relevant qualification for this specific function and
task
• Are authorized by the plant owner/operator
• Are familiar with federal/national regulations
• Before beginning work, the specialist staff must have read and understood the instructions
in the Operating Instructions and supplementary documentation as well as in the
certificates (depending on the application)
• Following instructions and basic conditions
The operating personnel must fulfill the following requirements:
• Being instructed and authorized according to the requirements of the task by the facility's
owner-operator
• Following the instructions in these Operating Instructions
3.2 Intended use
The Gammapilot FMG50 is a compact transmitter for non-contact level, point level, density
and concentration measurement. The detector is up to 3 m (9.84 ft) in length. The
Gammapilot FMG50 is certified according to IEC 61508 for safety-related operation up to SIL
2/3.
3.3 Hazardous area
If the measuring system is used in hazardous areas, the corresponding national standards and
regulations must be observed. The device is accompanied by separate "Ex documentation",
which is an integral part of these Operating Instructions. The installation specifications,
connection values and safety instructions listed in this supplementary documentation must be
observed.
• Technical personnel must be qualified and trained for the hazardous area.
• Comply with the metrological and safety-related requirements for the measuring point.
L
WARNING
‣
Observe the safety instructions associated with the device. These instructions depend on
the certificate ordered