Gammapilot FMG50 HART Commissioning
Endress+Hauser 21
2. Open the device in FieldCare or DeviceCare.
The dashboard (homepage) of the device is displayed:
A0039359
4 Screenshot: Commissioning Wizard
3. Click "Commissioning" to launch the Wizard.
4. Enter the appropriate value in each parameter or select the appropriate option. These
values are written directly to the device.
5. Click "Next" to go to the next page.
6. Once all the pages have been completed, click "Finish" to close the Wizard.
If you cancel the Wizard before all the necessary parameters have been entered, the
device may be in an undefined state. In such situations, it is advisable to reset the device
to the factory default settings.
7.3 Operation
7.3.1 Operation via FieldCare/DeviceCare
FieldCare/DeviceCare is an Endress+Hauser asset management tool based on FDT technology.
With FieldCare/DeviceCare you can configure all Endress+Hauser devices as well as devices
from other manufacturers that support the FDT standard. Hardware and software
requirements can be found on the Internet:
www.de.endress.com -> Search: FieldCare -> FieldCare ->Technical data
FieldCare supports the following functions:
• Configuration of transmitters in online mode
• Loading and saving of device data (upload/download)
• Documentation of the measuring point
Connection options:
• HART via Commubox FXA195 and the USB port on a computer
• Commubox FXA291 via the service interface
To Next Page
Loading...
