Levelflex M FMP40 FOUNDATION Fieldbus Mounting
Endress+Hauser 17
2.3.9 Turn housing
After mounting, the housing can be turned 350° in order to simplify access to the display and
the terminal compartment. Proceed as follows to turn the housing to the required position:
• Undo the fixing screws (1)
• Turn the housing (2) in the required direction
• Tighten up the fixing screws (1)
L00-FMP4xxxx-17-00-00-en-028
2.4 Post-installation check
After the measuring device has been installed, perform the following checks:
• Is the measuring device damaged (visual check) ?
• Does the measuring device correspond to the measuring point specifications such as process
temperature/pressure, ambient temperature, measuring range, etc..?
• Are the measuring point number and labeling correct (visual check ?
• Is the measuring device adequately protected against rain and direct sunlight (see Chapter
"Accessories" in the Operating Instructions on the CD-ROM) ?
1
1
2
2
F12/F23 housing T12 housing
allen key
4 mm/0.1”
To Next Page
Loading...
