Endress+Hauser Levelflex M FMP45 - Function Group System Parameters; Function Group Service

7 Description of Instrument Functions Levelflex M FMP40 and FMP45
54 Endress+Hauser
7.8 Function group "system parameters"
7.8.1 Function "tag no."
You can define the tag number with this function.
User input:
• 16 alphanumeric characters for HART instruments (8 using the HART universal command)
7.8.2 Function "protocol+sw-no."
This function shows the protocol and the hardware and software version: Vxx.yy.zz.prot.
Display:
xx: hw-version
yy: sw-version
zz: sw-revision
prot: protocoll type (e.g. HART)
7.8.3 Function "serial no."
This function displays the instrument serial number.
7.8.4 Function "distance unit"
You can select the basic distance unit with this function.
Selection:
•m
•ft
•mm
•inch
Dependence
m, mm: "format display" can only be "decimal".
The units are changed for the following parameters:
• empty calibr.
• full calibr.
•safetydistance
• offset
•measureddist.
• measured level
7.8.5 Function "download mode"
!
Note!
The parameter up- / download are not possible with the Levelflex M interface version.
7.9 Function group "service"
Parameters in the function group service are for use of the E+H Service only!
7.9.1 System error messages
See Chapter 10.2.