Nivector FTI26
18 Endress+Hauser
Ex approval
The devices are certified for use in hazardous areas and the relevant safety instructions are provided
in the separate "Safety Instructions" (XA01734F) document. Reference is made to this document on
the nameplate.
You will find information on the available certificates in the supplementary documentation
section → 21
Sanitary compatibility
The device has been developed for use in hygienic processes. The process-wetted materials meet the
requirements stipulated in EU 1935/2004, 10/2011, 2023/2006 and FDA 21 CFR 177.2415 (only
for order code for "Process connection", option "WDJ").
By affixing the 3-A symbol to the device, Endress+Hauser confirms compliance with the 3-A
Sanitary Standard No. 74-xx and No. 50-xx.
The following certificate copies can be ordered with the device (optional):→ 18
3-A
A0037165
EHEDG
• To avoid the risk of contamination, install the device in accordance with the design principles of
EHEDG, Document 37 "Hygienic Design and Application for Sensors" and Document 16 "Hygienic
Pipe Connections".
• Suitable connections and seals must be used in order to guarantee a hygienic design in accordance
with the specifications of 3-A and EHEDG.
• Information on 3-A and EHEDG-approved weld-in adapters can be found in the "Weld-in adapter,
process adapter and flanges" documentation, TI00426F/00/EN.
Hygiene approval
Process connections Option
1)
EHEDG 3-A
ISO228 G1" thread, 316L in conjunction with Tri-
Clamp 2" process adapter
WDJ + PI
ISO228 G1" thread, 316L in conjunction with G1"
weld-in adapter
WDJ + RI
1) See order code in Product Configurator
Manufacturer's Declaration
The following documents can be ordered with the device (optional):
• FDA conformity
• Regulation (EC) No. 1935/2004 on materials and articles intended to come into contact with food
Ordering information
Detailed ordering information is available from the following sources:
• In the Product Configurator on the Endress+Hauser website: www.endress.com -> Click "Corporate"
-> Select your country -> Click "Products" -> Select the product using the filters and search field ->
Open product page -> The "Configure" button to the right of the product image opens the Product
Configurator.
• From your Endress+Hauser Sales Center: www.addresses.endress.com
Product Configurator - the tool for individual product configuration
• Up-to-the-minute configuration data
• Depending on the device: Direct input of measuring point-specific information such as
measuring range or operating language
• Automatic verification of exclusion criteria
• Automatic creation of the order code and its breakdown in PDF or Excel output format
• Ability to order directly in the Endress+Hauser Online Shop
To Next Page
Loading...
Need help?
General
