Endress+Hauser Proline Promag L 400 - Page 44

Operation options Proline Promag L 400
44 Endress+Hauser
8.2.1 Operational display
Status area
Status signals
Failure Function check Out of specification Maintenance required
Diagnostic behavior Locking Communication
Alarm Warning Device locked Remote operation enabled
Display area
Measured variables
Symbol Meaning
Volume flow
Conductivity
Mass flow
Totalizer
The measurement channel number indicates which of the three totalizers is displayed.
Output
The measurement channel number indicates which of the outputs is displayed.
Status input
Symbols for measurement channel numbers
Measurement channel 1 to 4
The measurement channel number is displayed only if more than one channel is present for the same measured
variable type (e.g. Totalizer 1 to 3).
Symbols for diagnostic behavior
The diagnostic behavior pertains to a diagnostic event that is relevant to the displayed measured variable.
For more information about the symbols, refer to the "Status area" section (→  44)